Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.6.1. Check of a belt of a drive of auxiliary units
2.6.2. Check of thermal gaps in the mechanism of a drive of valves
2.6.3. Compression check
2.6.4. Removal and installation of a chain of a drive of the mechanism of a gazoraspredeleniye
2.6.4.1. Removal
2.6.4.2. Removal of a natyazhitel of a chain
2.6.4.3. Removal of a chain of a drive of the mechanism of a gazoraspredeleniye
2.6.4.4. Installation of a chain of a drive of the mechanism of a gazoraspredeleniye
2.6.4.5. Installation of a chain of a drive of the mechanism of a gazoraspredeleniye
2.6.4.6. Installation of a support of the engine No. 3
2.6.4.7. Installation of a support of a bolt of fastening of a pulley of a cranked shaft
2.6.4.8. Installation of a cover of a head of the block of cylinders
2.6.4.9. Final installation
2.6.5. Replacement of laying of the block of cylinders
2.6.6. Replacement of a forward epiploon of a cranked shaft
2.6.7. Replacement of a back epiploon of a cranked shaft
2.6.8. Removal and engine installation
2.7. Greasing system
2.8. Cooling system
2.9. Admission system
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. Ignition system
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







f084bf0f

2-6-4-8-ustanovka-kryshki-golovki-bloka-cilindrov.html

2.6.4.8. Installation of a cover of a head of the block of cylinders

Fig. 2.268. Scheme of drawing of silicone hermetic


Put silicone hermetic, as is shown in drawing 2.268.
Thickness of the roller of put hermetic: 2–6 mm.
Length of the roller of put hermetic: 6–26 mm.

Fig. 2.269. Poryatok of a tightening of bolts of fastening of a cover of a head of the block of cylinders


Tighten bolts of fastening of a cover of a head of the block of cylinders in an order shown in drawing 2.269.
Inhaling moment: 6. 9–10.8 N · m.

«previous page
2.6.4.7. Installation of a support of a bolt of fastening of a pulley of a cranked shaft
following page»
2.6.4.9. Final installation