Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.6.1. Check of a belt of a drive of auxiliary units
2.6.2. Check of thermal gaps in the mechanism of a drive of valves
2.6.3. Compression check
2.6.4. Removal and installation of a chain of a drive of the mechanism of a gazoraspredeleniye
2.6.4.1. Removal
2.6.4.2. Removal of a natyazhitel of a chain
2.6.4.3. Removal of a chain of a drive of the mechanism of a gazoraspredeleniye
2.6.4.4. Installation of a chain of a drive of the mechanism of a gazoraspredeleniye
2.6.4.5. Installation of a chain of a drive of the mechanism of a gazoraspredeleniye
2.6.4.6. Installation of a support of the engine No. 3
2.6.4.7. Installation of a support of a bolt of fastening of a pulley of a cranked shaft
2.6.4.8. Installation of a cover of a head of the block of cylinders
2.6.4.9. Final installation
2.6.5. Replacement of laying of the block of cylinders
2.6.6. Replacement of a forward epiploon of a cranked shaft
2.6.7. Replacement of a back epiploon of a cranked shaft
2.6.8. Removal and engine installation
2.7. Greasing system
2.8. Cooling system
2.9. Admission system
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. Ignition system
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








f084bf0f

2-6-4-4-ustanovka-cepi-privoda-mekhanizma-gazoraspredeleniya.html

2.6.4.4. Installation of a chain of a drive of the mechanism of a gazoraspredeleniye

Fig. 2.260. Alignment adjusting a shponochny flute of an asterisk of the crankshaft on an adjusting label


Level a shponochny flute of an asterisk of the crankshaft on an adjusting label, then establish the piston of the first cylinder in situation VMT (fig. 2.260).
Level adjusting labels on asterisks of camshafts so that they formed a straight line at alignment on the top horizontal surface of a head of the block of cylinders.
Establish a chain of a drive of the mechanism of a gazoraspredeleniye.

Fig. 2.261. Limiter removal


After installation of a regulator of a chain take out a wire or a paper clip established in a natyazhitel of a chain, and pull a chain of a drive of the mechanism of a gazoraspredeleniye. Remove the established limiter, at installation of a new natyazhitel of a chain (fig. 2.261).
Be convinced of that the chain of a drive of the mechanism of a gazoraspredeleniye has no sagging, and then again check correctness of installation of asterisks.
Turn a cranked shaft clockwise on two turns, and then check the moment of opening and closing of valves.

«previous page
2.6.4.3. Removal of a chain of a drive of the mechanism of a gazoraspredeleniye
following page»
2.6.4.5. Installation of a chain of a drive of the mechanism of a gazoraspredeleniye