Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.2.1. Engines of the L8 and LF models
2.2.2. Verification of the contents WITH / SN in the fulfilled gases
2.2.3. Compression measurement in engine cylinders
2.2.4. Check of a belt of a drive of auxiliary units
2.2.5. General information and safety measures at removal of the power unit
2.2.6. Hermetic removal
2.2.7. Removal and installation of the power unit
2.2.8. Check of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.9. Removal and installation of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.10. Chain of a drive of the mechanism of a gazoraspredeleniye
2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
2.2.12. Check of the operating oil valve (OCV) (L3)
2.2.13. Check of operation of the zolotnikovy valve (OCV) (L3)
2.2.14. The general repair operations on the power unit
2.2.15. Check of a head of the block of cylinders
2.2.16. Assembly of the block of cylinders (beginning)
2.2.16.1. Installation of covers of radical bearings
2.2.16.2. Installation of piston rings
2.2.16.3. Piston assembly
2.2.16.4. Installation of the shatunny bearing and cover
2.2.16.5. Assembly of the balancing block (L3 c mechanism of change of phases of a gazoraspredeleniye)
2.2.17. Assembly of the block of cylinders (termination)
2.2.18. Assembly of a head of the block of cylinders
2.2.19. Assembly of a drive of the mechanism of a gazoraspredeleniye
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Greasing system
2.8. Cooling system
2.9. Admission system
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. Ignition system
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








f084bf0f

2-2-16-3-sborka-porshnya.html

2.2.16.3. Piston assembly

Fig. 2.174. Scheme of an arrangement of locks of piston rings: 1–top ring; 2–top maslosjemny ring; 3–bottom maslosjemny ring; 4–dilator of a maslosjemny ring and second ring


Arrange locks of rings, as is shown in drawing 2.174.

Fig. 2.175. Piston installation with a rod in the cylinder


Insert the piston with a rod into the cylinder, the label in the form of an arrow should be turned to a forward part of the engine (fig. 2.175).

«previous page
2.2.16.2. Installation of piston rings
following page»
2.2.16.4. Installation of the shatunny bearing and cover