6.2.6.1. Removal

ATTENTION The gap between the switch of signals of braking and a pedal of a brake is regulated automatically when the switch of signals of braking is established in an opening on a pedal of a brake and turns for fixing. If the switch of signals of braking is not established properly, the gap can appear wrong that will lead to misoperation of signals of braking. Therefore, before installation of the switch of signals of braking on a pedal always check correctness of installation and the provision of a pedal of a brake it (is completely released).

After automatic adjustment of a gap of the switch of signals of braking repeated adjustment is impossible. Therefore, replace the switch new, at replacement of the amplifier of brakes or a pedal, or at performance of any works at which the pedal course will change.

Remove the storage battery and a platform of the storage battery.

Disconnect the brake highway (from the main cylinder).

Remove bolts and nuts of fastening of a pedal of a brake.

Take away the amplifier of brakes to a forward part of the car so that the fork of the amplifier of brakes did not adjoin to the lever of a pedal of a brake.

Remove a brake pedal.

Fig. 6.19. Order of removal of details of a pedal of a brake: 1–socket of the switch of signals of braking; 2–switch of signals of braking; 3–cable of a drive of a butterfly valve; 4–pedal of management of supply of fuel; 5–hinge axis; 6–brake pedal; 7–basic platform of a pedal