Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of brake system
6.2.2. Check of level of brake liquid in a tank of a hydraulic actuator of working brake system
6.2.3. Air removal from brake system
6.2.4. Check of the return valve of a vacuum hose (amplifier of brakes)
6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)
6.2.6. Removal and installation of a pedal of a brake
6.2.7. Removal and installation of the main brake cylinder
6.2.8. Check of the sensor of level of liquid
6.2.9. Removal and installation of the vacuum amplifier of brakes
6.2.10. Check of the vacuum amplifier of brakes
6.2.10.1. Check of operation of the vacuum amplifier
6.2.10.2. Tightness check
6.2.10.3. Check and adjustment of length of an acting rod
6.2.11. Dismantling and assembly of the main cylinder
6.2.12. Removal and installation of a forward brake disk
6.2.13. Replacement of forward brake shoes
6.2.14. Removal and installation of the back disk brake mechanism
6.2.15. Check of lay brake system
6.2.16. Removal, check and installation of the back sensor of speed of a wheel of ABS
6.2.17. Removal and installation of the hydraulic block of anti-blocking system of brakes
6.3. Tables
7. Onboard electric equipment
8. Body
 








f084bf0f

6-2-10-3-proverka-i-regulirovka-dliny-vystupayushhego-shtoka.html

6.2.10.3. Check and adjustment of length of an acting rod

By means of manual vacuum наcoca create in the amplifier of a brake vacuum – 66,7 kPas (–500 mm of mercury.).

Fig. 6.31. Adjustment of length of a press rod


Weaken a lock-nut and adjust length of a press rod so that the length "In" became equal to a preset value (fig. 6.31).
Regulate, while the gap between acting part of a rod and the screw does not become equal 0 mm – nominal length at indications of the vacuum gage of 66,7 kPas (-500 mm of mercury.).

«previous page
6.2.10.2. Tightness check
following page»
6.2.11. Dismantling and assembly of the main cylinder