Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.5.1. Coolant
8.5.2. Air filter
8.5.3. Block of central air of air
8.5.4. Evaporator
8.5.5. Broad valve
8.5.6. Condenser
8.5.7. Check of a radiator of a heater
8.5.8. Removal and installation of a back air line
8.5.9. Removal and installation of the compressor of central air of air
8.5.10. Dismantling and assembly of the obgonny coupling
8.5.11. Adjustment of the obgonny coupling
8.5.12. Check of the obgonny coupling
8.5.13. Removal and condenser installation
8.5.14. Condenser check
8.5.15. Removal and installation of lines of a coolant (LF)
8.5.15.1. Removal
8.5.15.2. Separation of an isolating joint
8.5.15.3. Installation
8.6. Tables
 







f084bf0f

8-5-15-3-ustanovka.html

8.5.15.3. Installation

Put compressor on sealing rings and connect tubes.
Tighten connections.
Tighten a bolt of connection of an isolating joint manually.

Fig. 8.82. Connection of pipes with an isolating joint


For connection of tubes with an isolating joint clamp covering party of a tube flat-nose pliers or the similar tool, and then tighten a connecting bolt or a nut a dinamometrichesky key (fig. 8.82).
Attach a covered tube or a hose twisting it in covering part until the spring on a covered tube will not appear behind a bell of a covering tube.
Execute operational tests of a contour of cooling.

NOTE
At replacement of a covered tube or a hose emergence after connection of a ring of the indicator specifies that connection is blocked.

«previous page
8.5.15.2. Separation of an isolating joint
following page»
8.6. Tables