Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.5.1. Coolant
8.5.2. Air filter
8.5.3. Block of central air of air
8.5.4. Evaporator
8.5.5. Broad valve
8.5.6. Condenser
8.5.7. Check of a radiator of a heater
8.5.8. Removal and installation of a back air line
8.5.9. Removal and installation of the compressor of central air of air
8.5.10. Dismantling and assembly of the obgonny coupling
8.5.11. Adjustment of the obgonny coupling
8.5.12. Check of the obgonny coupling
8.5.13. Removal and condenser installation
8.5.14. Condenser check
8.5.15. Removal and installation of lines of a coolant (LF)
8.5.15.1. Removal
8.5.15.2. Separation of an isolating joint
8.5.15.3. Installation
8.6. Tables
 








f084bf0f

8-5-15-2-razedinenie-izoliruyushhego-styka.html

8.5.15.2. Separation of an isolating joint

Fig. 8.79. Separation of pipes with an isolating joint


For separation of pipes with an isolating joint clamp covering party of a pipe flat-nose pliers or the similar tool, and then unscrew a connecting bolt or a nut (fig. 8.79).

Fig. 8.80. Installation of the special adaptation on the coupling with the spring lock


Establish the special adaptation on the coupling with the spring lock (fig. 8.80).
Insert an acting element of the special adaptation against the stop into a holder, supervising the provision of an acting element through the viewing.
Use the special adaptation to disconnect a covered pipe or a hose from a covering part extending a covered part of a tube or a hose.

Fig. 8.81. Razedineniye of tubes



NOTE
The covered tube or hose can easily from be disconnected from a covering part extending it by simultaneous pressing an acting element of the special adaptation (fig. 8.81).

«previous page
8.5.15.1. Removal
following page»
8.5.15.3. Installation