Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.5.1. Coolant
8.5.2. Air filter
8.5.3. Block of central air of air
8.5.4. Evaporator
8.5.5. Broad valve
8.5.6. Condenser
8.5.7. Check of a radiator of a heater
8.5.8. Removal and installation of a back air line
8.5.9. Removal and installation of the compressor of central air of air
8.5.10. Dismantling and assembly of the obgonny coupling
8.5.11. Adjustment of the obgonny coupling
8.5.12. Check of the obgonny coupling
8.5.13. Removal and condenser installation
8.5.14. Condenser check
8.5.15. Removal and installation of lines of a coolant (LF)
8.5.15.1. Removal
8.5.15.2. Separation of an isolating joint
8.5.15.3. Installation
8.6. Tables
 








f084bf0f

8-5-15-1-snyatie.html

8.5.15.1. Removal

Disconnect a negative wire from the storage battery.
Discharge a coolant.
Remove the tank of the hydraulic booster of a steering.
Remove a broad tank of system of cooling
Remove a cable of a drive of a butterfly valve.
Remove an arm of a hose of the hydraulic booster of a steering.
Remove in an order specified in the table. Do not allow the oil passage from the compressor.

ATTENTION
At hit of moisture or impurity in a cooling contour, cooling ability of a contour it will be lowered, abnormal noise also will be audible. Always close jams an open fitting after removal of any elements of a contour of cooling for prevention of hit of moisture or impurity in a contour.

«previous page
8.5.15. Removal and installation of lines of a coolant (LF)
following page»
8.5.15.2. Separation of an isolating joint