Mazda 3 since 2003
	1. Operation and car maintenance
	2. Engine
		2.1. General description of new engines of the L8, LF and L3 models
		2.2. Mechanical part of engines
		2.3. Appendix 1
		2.4. Appendix 2
		2.5. Appendix 3
		2.6. The Z6 engine – a mechanical part
			2.6.1. Check of a belt of a drive of auxiliary units
			2.6.2. Check of thermal gaps in the mechanism of a drive of valves
			2.6.3. Compression check
			2.6.4. Removal and installation of a chain of a drive of the mechanism of a gazoraspredeleniye
			2.6.5. Replacement of laying of the block of cylinders
			2.6.6. Replacement of a forward epiploon of a cranked shaft
			2.6.7. Replacement of a back epiploon of a cranked shaft
			2.6.8. Removal and engine installation
				2.6.8.1. Removal
				2.6.8.2. Removal of the socket of the main block of safety locks
				2.6.8.3. Removal of support of the engine No. 3 and No. 4
				2.6.8.4. Removal of a support of the engine and No. 4
				2.6.8.5. Installation of a support of the engine and No. 4
				2.6.8.6. Installation of a support of the engine No. 3
		2.7. Greasing system
		2.8. Cooling system
		2.9. Admission system
		2.10. Fuel system
		2.11. System of production of the fulfilled gases and system of decrease in toxicity
		2.12. Ignition system
		2.13. Control system
		2.14. Tables
	3. Transmission
	4. Running gear
	5. Steering mechanism
	6. Brake system
	7. Onboard electric equipment
	8. Body

2-6-8-6-ustanovka-opory-dvigatelya-n3.html

2.6.8.6. Installation of a support of the engine No. 3

Tighten hairpins of fastening of a support of the engine No. 3.

Inhaling moment: 7–13 N · m.

Establish a support of the engine No. 3 and temporarily tighten bolts and fastening nuts.

Tighten bolts of a support of the engine No. 3.

Remove a motor jack and an extra.

Fig. 2.286. Installation of the special adaptation for measurement of pressure of oil

Tighten bolts of fastening of a support of the engine No. 1 (fig. 2.286).

Inhaling moment: 93,1–116,6 N · m.