Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Greasing system
2.8. Cooling system
2.9. Admission system
2.9.1. Removal and installation of system of an admission
2.9.1.1. Removal
2.9.1.2. Installation
2.9.2. Removal and installation of a regulator of idling
2.9.3. Removal and installation of a pedal of management by supply of fuel
2.9.4. Check and adjustment of a cable of a drive of a butterfly valve
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. Ignition system
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








f084bf0f

2-9-1-2-ustanovka.html

2.9.1.2. Installation

Fig. 2.311. An order of installation of fastenings of a retsirkulyatsiya of the fulfilled gases


Establish bolts and a nut of fastening of a pipe of a retsirkulyatsiya of the fulfilled gases in an order shown in drawing 2.311.

Fig. 2.312. Combination of adjusting labels throttle branch pipe and air hose


Combine labels on a throttle branch pipe and an air hose (fig. 2.312).

NOTE
Before installation of an air line of system of an admission, be convinced that rubber fastenings on an arm of the storage battery are on the places.
At installation of an air line of system of an admission in rubber fastenings use soap water.

Be convinced of that two rubber fastenings are established on an arm of the storage battery.
Establish an air line of system of an admission in rubber fastenings.

Fig. 2.313. Installation of the panel of a radiator and air line of system of an admission


Using a bracket, fix the panel of a frame of a radiator and an air line of system of an admission as is shown in drawing 2.313.

Fig. 2.314. Installation of the socket of the RSM block


Completely insert the PCM block socket into the air filter and press the lever before click (fig. 2.314).
Establish other components as it should be, the return to removal.

«previous page
2.9.1.1. Removal
following page»
2.9.2. Removal and installation of a regulator of idling