Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Greasing system
2.7.1. Check of pressure of oil
2.7.2. Replacement of engine oil
2.7.3. Installation of the oil filter
2.7.4. Removal and installation of the oil pallet
2.7.5. Removal and installation of the oil pump
2.7.5.1. Removal
2.7.5.2. Installation
2.7.6. Dismantling, check and assembly of the oil pump
2.8. Cooling system
2.9. Admission system
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. Ignition system
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







f084bf0f

2-7-5-1-snyatie.html

2.7.5.1. Removal

Uncover the storage battery.
Disconnect a negative wire from the storage battery.
Remove the bottom cover together with a mudguard.
Merge from the engine cooling liquid.
Fix a broad tank of system of cooling so that it did not disturb work.
Remove a tank of the hydraulic booster of a steering with hoses.
Remove the pump of the hydraulic booster with hoses and tubes.
Disconnect the socket of the sensor of provision of a cranked shaft.
Place a plait of wires of the managing director oil the valve so that it did not disturb work.
Place an arm of a rope of an accelerator so that it did not disturb work.
Remove the following:
– forward wheel (right);
– driving belt;
– case of the air filter, RSM block knot, and air line of system of an admission;
– ignition coil;
– generator;
– the pump of cooling liquid;
– chain of a drive of the mechanism of a gazoraspredeleniye.

Fig. 2.295. Removal of the oil pump: 1–oil pump; 2–laying of the oil pump


Remove the oil pump and laying (fig. 2.295).

«previous page
2.7.5. Removal and installation of the oil pump
following page»
2.7.5.2. Installation