Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Greasing system
2.8. Cooling system
2.9. Admission system
2.10. Fuel system
2.10.1. Removal and installation of the block of the fuel pump
2.10.1.1. Removal
2.10.1.2. Installation
2.10.1.3. Check of leakage of fuel after installation of the block of the pump
2.10.2. Removal and installation of a fuel nozzle
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. Ignition system
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







f084bf0f

2-10-1-2-ustanovka.html

2.10.1.2. Installation

NOTE
If on laying there will be a gasoline, the block of the fuel pump will be turned and it cannot be fixed in the specified situation.
Carefully wipe all gasoline from laying.



Fig. 2.323. Combination of adjusting labels on the fuel pump and a fuel tank


Combine adjusting labels on the fuel pump and a fuel tank, as is shown in drawing 2.323.
Establish the special adaptation.
Using the special adaptation, tighten a cover of the fuel pump within the specified moment of an inhaling, without allowing shift of adjusting labels.
If the specified moment of an inhaling does not manage to achieve, replace a cover of the fuel pump and laying.
If the specified moment of an inhaling does not manage to achieve after replacement of a cover of the fuel pump and laying, replace a fuel tank.
Moment of an inhaling of a cover of the fuel pump: 80–90 N · m.

«previous page
2.10.1.1. Removal
following page»
2.10.1.3. Check of leakage of fuel after installation of the block of the pump