8.5.10.1. Removal of a bolt of the obgonny coupling

Fig. 8.70. Removal of a bolt of the obgonny coupling

At removal and installation of a bolt hold press a disk, as is shown in drawing 8.70.

At installation of the new compressor of central air of air replace a bolt.

Fig. 8.71. Hermetic removal from the compressor

After removal of a stator and the device of thermal protection completely remove hermetic from the compressor of central air of air (fig. 8.71).

Before installation put about 1 g of silicone hermetic (KE-347W hermetic or similar) on a contact surface of the device of thermal protection, then accurately establish it on the compressor of central air of air, without leaving gaps.

At installation of a new stator and the device of thermal protection, replace the screw.

At installation of a new stator and the device of thermal protection, replace a collar.

Fig. 8.72. Scheme of replacement of a lock ring

At installation of a new press disk, a pulley of the compressor of central air of air, a stator or the case of the compressor replace a lock ring (fig. 8.72).