Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.3. Body glazing
8.3.1. Windscreen removal
8.3.2. Windscreen installation
8.3.3. External rear-view mirrors
8.3.4. Removal and installation of an external mirror with the electric drive
8.3.5. Dismantling and assembly of an external mirror with the electric drive
8.4. Seats
8.5. Conditioner and heater
8.6. Tables



8.3.2. Windscreen installation

The windscreen can be established incorrectly if the sealant has damages or glass is pushed out by pressure of air during opening and closing of doors at the lifted opuskny glasses. Before the termination of an ustanvka of a windscreen leave all windows open.

Fig. 8.43. Removal of the remains of an old sealant

Cut off an old sealant the razor so that the thickness of the remained layer of a sealant on perimeter of a frame made 1-2 mm (fig. 8.43).
If the sealant in any place completely separated from a body, put on this place after degreasing a quantity of a first coat and let's to it dry up in an iyecheniye about 30 minutes. After that put a sealant layer in thickness of 2 mm.
Clear and degrease a strip in width about 50 mm on perimeter of a windscreen and a contact surface on a body.
At installation of a reusable windscreen, execute the following procedure:

Fig. 8.44. Installation of pins

Attach pins in the places marked at removal (fig. 8.44).
Establish a windscreen fringing.
Put a first coat for glass on glass and a first coat for a body on a body and a fringing, let's to a first coat dry up within about 30 minutes.

Fig. 8.45. The general scheme of installation flew down

Do not allow hit on contact surfaces of dirt and konsistentny greasing, do not concern contact surfaces. Otherwise, the first coat will not have sufficient adhesion to glass and body surfaces that can lead to a leak.

Fig. 8.46. The scheme of drawing of hermetic on a glass surface

Put hermetic on a glass surface, as is shown in drawing 8.46.
Insert pins into a body, then establish a windscreen.
Press on windscreen pins that they entered into uvulas on a body.

Fig. 8.47. Size of a gap of a ledge

Create pressure on glass perimeter so that the size of a gap of a ledge of a fringing of glass corresponded to norm (fig. 8.47).
Establish components as it should be, the return to removal
Give to hermetic completely полимеризоваться.
Time of complete polymerization of hermetic: 24 h.

«previous page
8.3.1. Windscreen removal
following page»
8.3.3. External rear-view mirrors