7.5.3.4. Switching off of a mode of anticreeping blocking

Enter an operating code to deactivate anticreeping system and to renew normal operation of the audioblock.

1. Establish the ignition switch in the situation ACC. (On the display there will be a blinking indication of "CODE".)

2. At first press the AUTO-M button, then at the same time press the channel 6 button approximately on 2 with while on the display there will be no «CODE» indication.

NOTE Procedure 3 should be executed during 10 with the ambassador of procedure 2.

Fig. 7.80. Scheme of a mode of anticreeping blocking 1

3. Buttons of a choice of the channel 1-4 are used for input of the chosen code. The button 1 sets the first figure of a code, 2 – the second, 3 – a third, 4 – the last figure. Enter number during 10 pages. If indication on the display disappears, repeat procedures since the first.

Fig. 7.81. Scheme of a mode of anticreeping blocking 2

ATTENTION Three consecutive mistakes, including installation of the switch of ignition in the situation LOCK and shutdown the audioblka, makes active anticreeping system then to restore normal operation of the audioblock it will be impossible.

4. During code display, press the AUTO-M button, then at the same time press the channel 6 button approximately during 2 pages. Indication of "CODE" will be displayed on the display about 5 pages.

Fig. 7.82. Scheme of a mode of anticreeping blocking 3

5. If on the display there is an indication "Err" (mistake), repeat procedure since operation 1.