7.5.3.2. Code installation

Carry out each procedure (1-3) during 10 with, otherwise procedure of installation of a code will be stopped.

1. Establish the ignition switch in the situation ACC, and then switch off the audioblock.

2. At first press the AUTO-M button, then at the same time press the channel 6 button approximately on 2 with while on the display there will be no «CODE» indication.

Fig. 7.72. Coding 1 scheme

3. Press the AUTO-M button again, then at the same time press the channel 6 button while on the display there will be no rectangles.

Fig. 7.73. Coding 2 scheme

4. Choose a personal code and write down it before input. If to enter number, and then to forget it, at shutdown of a food of the module the audioblock will not function.

5. Buttons of a choice of the channel 1-4 are used for input of the chosen code. The button 1 sets the first figure of a code, 2 – the second, 3 – a third, 4 – the last figure. Enter number during 10 pages. If indication on the display disappears, repeat procedures since the first.

Fig. 7.74. Coding 3 scheme

NOTE Procedure 6 should be executed during 10 with the ambassador of procedure 5.

6. During code display, press the AUTO-M button, then at the same time press the channel 6 button approximately during 2 pages. Indication of "CODE" will be displayed on the display about 5 pages. After indication disappears, number of a code will be established.

Fig. 7.75. Coding 4 scheme

7. If on the display there is an indication «Err» (mistake), repeat procedure since 1. If the mistake at input of a code repeats three times, establish the ignition switch in the situation LOCK and repeat procedure procedure since operation 1.