7.5.3.3. Code cancellation

Carry out each procedure (1-3) during 10 with, otherwise procedure of installation of a code will be stopped.

1. Establish the ignition switch in the situation ACC, and then switch off the audioblock.

2. At first press the AUTO-M button, then at the same time press the channel 6 button approximately on 2 with while on the display there will be no «CODE» indication.

Fig. 7.76. Scheme of cancellation of the coding 1

3. Press the AUTO-M button again, then at the same time press the channel 6 button while on the display there will be no rectangles.

4. Buttons of a choice of the channel 1-4 are used for input of an operating code. The button 1 sets the first figure of a code, 2 – the second, 3 – a third, 4 – the last figure. Enter number during 10 pages. If indication on the display disappears, repeat procedures since the first.

Fig. 7.77. Scheme of cancellation of the coding 2

Fig. 7.78. Scheme of cancellation of the coding 3

NOTE Procedure 5 should be executed during 10 with the ambassador of procedure 4.

5. During code display, press the AUTO-M button, then at the same time press the channel 6 button approximately during 2 pages. Indication of "CODE" will be displayed on the display about 5 pages. After indication disappears, number of a code will be removed.

Fig. 7.79. Scheme of cancellation of the coding 4

6. If on the display there is an indication "Err" (mistake), repeat procedure since 4.