|
5-3-5-snyatie-i-ustanovka-nasosa-gidrousilitelya.html
5.3.5. Removal and installation of the pump of the hydraulic booster
Remove a driving belt.
Disconnect the socket of the sensor of pressure.
Disconnect the pressure head pipeline.
Disconnect soaking-up hose.
|
|
Fig. 5.30. Pump of the hydraulic booster: 1–driving belt; 2–socket of the sensor of pressure; 3–pressure head pipeline; 4–a soaking-up hose; 5–pump of the hydraulic booster
|
Turn off three bolts of fastening and remove the pump of the hydraulic booster.
|
|
Fig. 5.32. Installation of the pump of the hydraulic booster in a vice with soft sponges
|
Fix the pump of the hydraulic booster, using the special adaptation (fig. 5.32).
|
ATTENTION
Use the special adaptation to prevent pump damage when fastening in a vice.
|
Lift a clip ear, using a screw-driver with a flat shliyets.
|
|
Fig. 5.33. Removal of a clip of the pump of the hydraulic booster
|
Remove a clip a screw-driver with a flat shliyets and a hammer, as is shown in drawing 5.33.
|
|
Fig. 5.31. Components of the pump of the hydraulic booster: 1–pump of the hydraulic booster; 2–pressure sensor; 3–socket; 4–sealing rings; 5–the operating valve; 6–spring; 7–clip; 8–a broad tank of a steering drive with the amplifier; 9–sealing ring; 10-back case of the pump; 11-sealing ring; 12-clip; 13-statorny ring; 14-rotor; 15-blade; 16-lateral plate; 17-sealing ring; 18-epiploon; 19-shaft; 20-forward case of the pump
|
Disassemble other components, being guided by the order specified in drawing 5.31.
| 