Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
4.1. Wheels and tires
4.1.1. Adjustment of corners of installation of wheels
4.1.2. Adjustment of an angle of rotation of forward wheels
4.1.2.1. Adjustment of a convergence of wheels
4.1.3. Adjustment of installation of back wheels
4.1.4. Balancing of wheels (16-inch and 17-inch cast light-alloy wheels)
4.2. Suspension bracket
4.3. Tables
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







f084bf0f

4-1-2-regulirovka-ugla-povorota-perednikh-koles.html

4.1.2. Adjustment of an angle of rotation of forward wheels




Adjustment of an angle of rotation
Weaken a lock-nut of a tip of the helmsman of draft.
Remove a collar of a cover of a lath.
Rotating steering draft, adjust an angle of rotation.

NOTE
The course of the right and left steering draft should be identical.


Fig. 4.2. Rotation of steering drafts


Rotating steering draft, achieve that the difference between the size L shown in drawing, on the right and at the left was less norm (fig. 4.2).
Standard: 3 mm or are less
Tighten a lock-nut of a tip of steering draft.
Inhaling moment: 68,6–98,0 N · m.
Eliminate a perekruchivaniye of a cover of a lath.
Establish and fix a collar of a cover of a lath.
After adjustment of an angle of rotation, always check and regulate a convergence corner.

«previous page
4.1.1.1. Preliminary check of adjustment of installation of wheels
following page»
4.1.2.1. Adjustment of a convergence of wheels