Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
4.1. Wheels and tires
4.1.1. Adjustment of corners of installation of wheels
4.1.2. Adjustment of an angle of rotation of forward wheels
4.1.2.1. Adjustment of a convergence of wheels
4.1.3. Adjustment of installation of back wheels
4.1.4. Balancing of wheels (16-inch and 17-inch cast light-alloy wheels)
4.2. Suspension bracket
4.3. Tables
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








f084bf0f

4-1-2-1-regulirovka-skhozhdeniya-koles.html

4.1.2.1. Adjustment of a convergence of wheels

Weaken a lock-nut of a tip of steering draft.
Remove a collar of a cover of a lath.
Adjust a convergence of wheels rotation of both steering drafts (left and right) in opposite directions on identical size.

NOTE
For one turn of steering draft of one wheel the corner of a convergence changes approximately on 6 mm.
Each steering draft has the right carving.

For increase in a corner of a convergence, rotate the right steering bent for of a forward part of the car, and the left steering bent for of a back part of the car on identical size.
Tighten a lock-nut of a tip of steering draft.
Inhaling moment: 68,6–98,0 N · m.
Be convinced of that the cover of a lath is not overwound and establish a collar of a cover of a lath.

«previous page
4.1.2. Adjustment of an angle of rotation of forward wheels
following page»
4.1.3. Adjustment of installation of back wheels