Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.4.1. General information
3.4.2. Forward power shafts
3.4.3. Removal and installation of a nave of a forward wheel
3.4.4. Removal and installation of a nave of a back wheel
3.4.5. Removal and installation of a nave of a back wheel
3.4.6. Removal and installation of a forward connecting shaft
3.4.7. Assembly and dismantling of a connecting shaft
3.4.8. Removal and installation of a power shaft (cars with a mechanical transmission)
3.4.9. Removal and installation of a power shaft (cars with an automatic transmission)
3.4.9.1. Removal
3.4.9.2. Installation
3.4.10. Removal and installation of a power shaft (cars with a mechanical transmission)
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







f084bf0f

3-4-9-1-snyatie.html

3.4.9.1. Removal

Fig. 3.146. Removal of a collar of a cover (from a wheel) special flat-nose pliers


Remove a cover collar (from a wheel) special flat-nose pliers, as shown drawing 3.146.
Unbend a screw-driver blocking clips of a collar.

Fig. 3.147. Removal of a collar of a cover (from a transmission)


Extend the collar end (fig. 3.147).

Fig. 3.148. Marking drawing on the case of the hinge and a power shaft


Mark the case of the hinge and a shaft for the subsequent assembly (fig. 3.148).
Remove the hinge case.

Fig. 3.149. Marking drawing on a power shaft and трипод


Mark a shaft and трипод for the subsequent assembly (fig. 3.149).
Remove a lock ring, using pincers for removal and installation of lock rings.
Remove tripodny connection from a shaft.

ATTENTION
Do not strike blows on триподу with a hammer.

NOTE
The cover from a wheel should not act in film, except for cases of replacement of a cover, a shaft or the spherical hinge. Do not remove a tape while the cover is not accurate.


Fig. 3.150. Protection шлицов power shaft


Wrap up shlitsa of a shaft a sticky tape (fig. 3.150).
Remove a cover.

NOTE
Do not remove a rotor of the sensor of anti-blocking system of brakes (cars with anti-blocking system of brakes) if it is not required. Do not use repeatedly removed rotor of the sensor.


Fig. 3.151. Removal of a rotor of the sensor of anti-blocking system of brakes from a power shaft


Bring down a rotor of the sensor of anti-blocking system of brakes from a power shaft a chisel (fig. 3.151).
Remove a dynamic damper.

«previous page
3.4.9. Removal and installation of a power shaft (cars with an automatic transmission)
following page»
3.4.9.2. Installation