Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.1.1. General information
3.1.2. Check and adjustment of a pedal of coupling
3.1.2.1. Adjustment of height of provision of a pedal
3.1.2.2. Check and adjustment of a free wheeling of a pedal of coupling
3.1.2.3. Verification of the provision of switching off of coupling
3.1.2.4. Removal and installation of a pedal of coupling
3.1.2.5. Removal and installation of tubes of a hydraulic actuator of coupling
3.1.2.6. Removal and installation of the main cylinder of a drive of switching off of coupling
3.1.2.7. Removal, check and coupling installation
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







f084bf0f

3-1-2-5-snyatie-i-ustanovka-trubok-gidroprivoda-scepleniya.html

3.1.2.5. Removal and installation of tubes of a hydraulic actuator of coupling

NOTE
For liquid of a hydraulic actuator of brake system and coupling the general tank is used.

If tubes of a hydraulic actuator of coupling were disconnected at carrying out procedure, add working liquid of a hydraulic actuator of coupling (brake liquid), remove air from system and check on absence of leak after procedure performance.
Lift the receiver a coupling hydraulic actuator, using the special adaptation (49 0259 770B). Establish a tube of a hydraulic actuator of coupling, using a combination of the special adaptation of a dinamometrichesky key.

«previous page
3.1.2.4. Removal and installation of a pedal of coupling
following page»
3.1.2.6. Removal and installation of the main cylinder of a drive of switching off of coupling