Mazda 3 since 2003
	1. Operation and car maintenance
	2. Engine
		2.1. General description of new engines of the L8, LF and L3 models
		2.2. Mechanical part of engines
		2.3. Appendix 1
		2.4. Appendix 2
		2.5. Appendix 3
		2.6. The Z6 engine – a mechanical part
			2.6.1. Check of a belt of a drive of auxiliary units
			2.6.2. Check of thermal gaps in the mechanism of a drive of valves
			2.6.3. Compression check
			2.6.4. Removal and installation of a chain of a drive of the mechanism of a gazoraspredeleniye
			2.6.5. Replacement of laying of the block of cylinders
			2.6.6. Replacement of a forward epiploon of a cranked shaft
				2.6.6.1. Removal
				2.6.6.2. Installation
			2.6.7. Replacement of a back epiploon of a cranked shaft
			2.6.8. Removal and engine installation
		2.7. Greasing system
		2.8. Cooling system
		2.9. Admission system
		2.10. Fuel system
		2.11. System of production of the fulfilled gases and system of decrease in toxicity
		2.12. Ignition system
		2.13. Control system
		2.14. Tables
	3. Transmission
	4. Running gear
	5. Steering mechanism
	6. Brake system
	7. Onboard electric equipment
	8. Body

2-6-6-1-snyatie.html

2.6.6.1. Removal

Uncover the storage battery.

Disconnect a negative wire from the storage battery.

Remove a driving belt.

Fix a pulley of a cranked shaft, using special adaptations.

Unscrew a bolt of fastening of a pulley of a cranked shaft.

Cut off a knife the worker an epiploon edge.

Fig. 2.278. Removal of a forward epiploon

Remove an epiploon, using a screw-driver with a flat shliyets wrapped up by rags to prevent damage of an epiploon of a cranked shaft (fig. 2.278).