Mazda 3 since 2003
	1. Operation and car maintenance
	2. Engine
		2.1. General description of new engines of the L8, LF and L3 models
		2.2. Mechanical part of engines
		2.3. Appendix 1
		2.4. Appendix 2
		2.5. Appendix 3
		2.6. The Z6 engine – a mechanical part
		2.7. Greasing system
		2.8. Cooling system
		2.9. Admission system
		2.10. Fuel system
		2.11. System of production of the fulfilled gases and system of decrease in toxicity
		2.12. Ignition system
		2.13. Control system
			2.13.1. Removal and installation of the sensor of temperature of cooling liquid of the engine
			2.13.2. Removal and installation of the sensor of provision of a cranked shaft
			2.13.3. Removal and installation of the sensor of provision of a butterfly valve
		2.14. Tables
	3. Transmission
	4. Running gear
	5. Steering mechanism
	6. Brake system
	7. Onboard electric equipment
	8. Body

2-13-1-snyatie-i-ustanovka-datchika-temperatury-okhlazhdayushhejj-zhidkosti-dvigatelya.html

2.13.1. Removal and installation of the sensor of temperature of cooling liquid of the engine

Uncover the storage battery.

Disconnect a negative wire from the storage battery.

Execute the following procedure for ensuring convenience of access.

Remove the air filter.

Take aside a pipe of a retsirkulyatsiya of the fulfilled gases (from an inlet collector).

Merge from the engine cooling liquid.

Fig. 2.341. Installation of the special adaptation for removal of the sensor of temperature of cooling liquid

Establish the special adaptation on the sensor of temperature of cooling liquid (fig. 2.341).

Remove the sensor of temperature of cooling liquid.

Replace laying.

Establish as it should be, the return to removal.

The moment of an inhaling of the sensor of temperature of cooling liquid: 15,7–23,5 N · m.