Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. Power supply system
7.2.1. Storage battery
7.2.1.1. Check of degree of a zaryazhennost of the battery
7.2.1.2. Tension of the storage battery
7.2.1.3. Check under loading
7.2.1.4. Leak current
7.2.1.5. Charging of the storage battery
7.2.1.6. A charging of completely discharged battery room of the battery
7.2.1.7. Care of the storage battery
7.2.1.8. Storage of the storage battery
7.2.1.9. Removal and installation of the storage battery
7.2.2. Generator
7.2.3. Starter
7.3. Lighting system
7.4. Screen wipers and stekloomyvatel
7.5. Immobilizer
7.6. Electric equipment checks
7.7. Tables
8. Body
 








f084bf0f

7-2-1-4-tok-utechki.html

7.2.1.4. Leak current

Be convinced of that the switch of ignition is in situation it is switched off, and the key is taken from the ignition lock.
Disconnect a negative wire from the storage battery.
Measure a current between a negative pole of the battery and a negative wire of the storage battery.
If the current of leak does not correspond to norm, measure a leak current, deleting one by one fuses from the main block of safety locks and the block of safety locks.

ATTENTION
Inclusion of electric consumers at measurement of a current of leak can lead to damage of the measuring device.

Standard current: 20 мА (maximum).
Check and repair plaits and sockets of safety locks at which removal the measured current decreased.

«previous page
7.2.1.3. Check under loading
following page»
7.2.1.5. Charging of the storage battery