4.2.2.3. Installation

Temporarily establish a cylindrical spring, a protective cover and a rubber support on the shock-absorber so that the bottom edge of a cylindrical spring was located on a ledge of the bottom cup of a spring.

Fig. 4.14. Marking of components of an amortizatorny rack

Mark a cylindrical spring, a protective cover and a rubber support for appropriate installation, as is shown in drawing fig. 4.14.

Level labels of a cylindrical spring and a protective cover. Wrap up a cylindrical spring and a protective cover a piece of a fabric, then establish special adaptations.

Fig. 4.15. Compression of a cylindrical spring

Compress a cylindrical spring, using special adaptations (fig. 4.15).

Establish the shock-absorber so that the bottom edge of a cylindrical spring was located on a ledge of the bottom cup of a spring.

Make sure that labels on the shock-absorber and a protective cover coincide.

Establish a rubber support and a nut of a rod of the piston, then remove special adaptations.

Moment of an inhaling of a nut of a rod of the piston: 39,2–52,9 N · m.

Fig. 4.16. Installation of carving hairpins

Establish carving hairpins at an angle 27-33 ° concerning a stabilizer rack (the center line), in the direction to car inside (fig. 4.16).

Fig. 4.17. Installation of a fork of the shock-absorber

Establish a fork of the shock-absorber and level it on labels together with a dynamic damper (fig. 4.17).

Tighten a bolt of fastening of a fork.

Other components establish as it should be, the return to removal.