Mazda 3 since 2003
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.4.1. General information
3.4.2. Forward power shafts
3.4.3. Removal and installation of a nave of a forward wheel
3.4.4. Removal and installation of a nave of a back wheel
3.4.5. Removal and installation of a nave of a back wheel
3.4.6. Removal and installation of a forward connecting shaft
3.4.6.1. Preliminary check of a connecting shaft
3.4.6.2. Removal
3.4.7. Assembly and dismantling of a connecting shaft
3.4.8. Removal and installation of a power shaft (cars with a mechanical transmission)
3.4.9. Removal and installation of a power shaft (cars with an automatic transmission)
3.4.10. Removal and installation of a power shaft (cars with a mechanical transmission)
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








f084bf0f

3-4-6-2-snyatie.html

3.4.6.2. Removal

Merge oil from a transmission.
Remove the sensor of anti-blocking system of brakes.

Fig. 3.126. Removal of the spherical hinge of a tip of the helmsman of draft


By means of the special adaptation remove the sharovy hinge of a tip of the helmsman of draft (fig. 3.126).

Fig. 3.127. Removal of the spherical hinge of the bottom back lever


By means of the special adaptation remove the sharovy hinge of the bottom back lever (fig. 3.127).

Fig. 3.128. Removal of a support of the back brake mechanism


Remove a support of the back brake mechanism and suspend it on a wire (fig. 3.128).

ATTENTION
Sharp edges of a connecting shaft can cut or punch an epiploon. Be careful at separation of a connecting shaft from a transmission.

Extend a connecting shaft directly.

Fig. 3.129. Installation of the special adaptation for keeping of a semi-axial gear wheel


Establish the special adaptation for keeping of a semi-axial gear wheel after removal of a connecting shaft in a transmission.
Other components remove and establish as it should be, the return to removal.

Fig. 3.130. Installation of a new clip on a connecting shaft


Before installation put on a connecting shaft a new clip a cut up (fig. 3.130).
After installation measure external diameter.
If it exceeds norm, repeat installation with use of a new clip.
Maximum external diameter: 31,2 mm.

«previous page
3.4.6.1. Preliminary check of a connecting shaft
following page»
3.4.7. Assembly and dismantling of a connecting shaft